Sliding Door Repair Services in New Smyrna Beach
Rollers, tracks, locks, handles, seals and glass for every kind of slider, from a beachside condo balcony door to a family home lanai. New doors are expensive and rarely needed, so repair always comes first.
Roller Repair & Replacement
Most sliders in New Smyrna Beach roll on small steel wheels, and salt air eats them. Once they rust, the door gets heavy, grinds and starts wearing down the track. We lift the panel out, fit stainless steel rollers made for the coast, and set the height so the door glides and locks.
What you'll notice
- You need two hands to open it
- Grinding or crunching as it moves
- Orange rust at the bottom of the panel
- The door sits low and drags
- The lock stopped lining up
What we do
- Lift the panel off the rail, with two people on big glass
- Pull the rusted rollers and size the replacements
- Fit stainless rollers that won’t rust out
- Vacuum the sand from the track and check the rail
Track Repair
Every trip to the beach brings sand back through the slider, and it settles in the bottom track where it acts like sandpaper. We vacuum and clean the track, straighten dents, and where the rail is worn we fit a stainless steel track cap, so you get a smooth surface without replacing the frame.
What you'll notice
- A gritty, crunchy feel when it slides
- It catches in the same spot on every slide
- A visible groove in the rail
- Corrosion along the track
- The panel has come off the rail
What we do
- Vacuum sand and grit out of the track and sill
- Look for grooves, dents and corrosion on the rail
- Straighten the rail or cover it with a stainless cap
- Swap the rollers if they chewed up the track
Lock Repair & Replacement
Salt air corrodes the small springs and cams inside a sliding door lock, and a panel that drops even a little stops the latch from catching. We realign the panel and keeper or replace the lock, which matters for beach homes and rentals that sit empty part of the year.
What you'll notice
- You have to push or lift the door to lock it
- The latch misses the keeper
- The lever is stiff or does nothing
- Rust around the lock
- The door rattles when locked
What we do
- See if the panel has sunk on worn rollers
- Move the keeper so the latch lines up
- Free up or replace a corroded latch
- Fit a new lock body if the old one is shot
Handle Repair & Replacement
Handles on oceanfront doors pit, fade and loosen fast. We match the hole spacing and finish of your door, and use corrosion-resistant hardware so the new set lasts.
What you'll notice
- The handle wobbles
- Pitted or corroded finish
- Cracked or broken handle
- Stiff latch lever
- Missing screws or trim
What we do
- Measure the hole spacing on your panel
- Find a matching set in a corrosion-resistant finish
- Mount the new handles and latch
- Line the latch up with the keeper
Weatherstripping & Leak Repair
Ocean-facing doors take wind-driven rain all summer and through storm season. Flattened pile, sand-clogged weep holes and a panel that has sunk on tired rollers let that water through. New seals, cleared drainage and a level panel keep the floor dry.
What you'll notice
- Puddles inside after a summer storm
- Daylight or a draft along the panel edge
- Sand or bugs getting in
- Flattened or missing seal strips
- The AC running harder than it should
What we do
- Track down where the rain or wind gets in
- Pull the flattened pile and fit new seal
- Flush sand out of the weep holes
- Level the panel so it closes tight
Glass Replacement
Cracked glass is a safety issue, and fog between double panes means the seal has failed, which happens sooner in heat and humidity. We replace the glass and keep your frame, including impact-rated glass, for far less than a new door.
What you'll notice
- A chip or crack in the pane
- Mist trapped between the two layers
- Glass that rattles when the door moves
- Storm or impact damage
- Cloudy glass that won’t wipe clean
What we do
- Measure the pane and confirm the glass type
- Order tempered, insulated or impact glass to fit
- Take the panel down and remove the old glass
- Set the new glass in your frame
What the beach does to sliding doors.
Salt air
Salt spray rusts standard steel rollers and lock parts, sometimes in just a few years. We replace them with stainless steel that holds up to ocean air.
Sand
Sand blows into the bottom track and grinds it like sandpaper. We clean, straighten and cap worn tracks so the door rolls smoothly again.
Storms
Ocean wind drives rain under worn seals. New weatherstripping and a level, properly adjusted door keep the water out.
Where prices start.
We accept cash, check and all major cards · Paid only once the door works
Book your free estimate
Questions about the work
All questions →Do you use stainless steel parts?
Yes, wherever they’re available for your door. Stainless rollers and track caps last much longer in salt air than standard steel.
Is it worth fixing an old slider instead of buying a new one?
Almost always. Rollers, a track cap and an adjustment usually cost a small fraction of a new door, as long as the frame and glass are in good shape.
Why do sliding doors wear out so fast at the beach?
Salt air corrodes steel rollers and lock parts, and sand in the track works like sandpaper. Stainless parts and regular track cleaning make a big difference.
Do you repair the screen doors on sliders too?
Yes. Screen doors get the same salt and sand treatment, so we replace their rollers and latches and rescreen torn panels, pet screen included.
What kinds of sliding doors do you repair?
Aluminum and vinyl patio sliders, condo balcony doors, impact-rated doors and older doors from most of the brands found in Volusia County homes.
Stuck slider at the beach house? Call us.
Rollers, tracks, locks and seals for homes and condos from Bethune Beach to Edgewater.